IGF sticky NEEDED!

[Micro]

dude i am confused has fuck, let me get this straight

1- i should put 5% vineger straight directly into power, then when its time to inject pull out desired amount then add BW to needle

OR???????

2- mix 5% vineger w/ BW at 1/8 vineger 7/8 BW to get desired consentration then add this to powder

No, you have to filter the vinegar and distilled water together to make AA. Then after you do all the filtering, that is when you take the solution that you just made up using vinegar and distilled water. You take that solution and inject it into your IGF vial that contains the powder.

Only use BW when your ready to do your injection

Micro

 

[littlenutz]

who has used igf or gh in a seo filled muscle?

 

[pinkpanthar]

I've seen this post a few times, on different boards

The problem I have with this method is that it says to mix the AA and the water together and that I believe is misleading the IGF should only be reconstituted with AA only and the water just used at time of injection.

Below is a couple of quotes from other areas


LR3-IGF-1 Reconstitution Instructions:

1mg of lyophilized LR3-IGF-1


Inject 1ml of AA solution into your vial of IGF,be cautious of the
vacuum in the IGF vial.You will need to control the syringe plunger
so the AA does not forcefully spray down onto the IGF powder.I
would suggest 'venting' the vial first to release this vacuum.You
want to trickle it down the side of the vial slowly and then swirl
the solution gently to mix it into a clear solution.

On a 1ml slin pin each tick is 20mcg of IGF.Draw out the
appropriate amount of IGF and then switch to your vial of sodium
chloride water to dilute it.That's all there is to it.

The most important points I would like to make clear are:

THE ONLY THING that comes in contact with the powder IGF is
the acetic acid(AA) solution being injected into its vial.NOTHING
ELSE is ever injected
into your vial of IGF concentrate,ONLY the AA.You suck up the
sodium chloride water separately.

DO NOT use BA to mix this IGF.That can/will work for gropep IGF
and some others perhaps,but it will turn this chinese produced IGF
into a sludge.Dont do it.

From Omegalabs forum

Ok, guys you can mix your IGF 2 ways, with Bwater or with out. IF you don't plan on using Bwater simply draw the proper amount(your choice) of MCGs into your slin pin and inject. SIMPLE!

Now if you plan to use Bwater along with your IGF LISTEN CAREFULLY!!
FIRST, you draw the IGF in the pin(your choice of MCGs. DO NOT DRAW WATER INTO YOUR PIN FIRST BECAUSE YOU RISK DRIPING WATER INTO YOUR MAIN VIAL AND DAMAGING YOUR IGF DUE TO THE TIME FACTOR IN WATER!! After you draw your IGF you then proceed to draw up your water. You can use any amount of water you choose but i recommend just fill it up but leave enough room in the pin so the liquid has room to stir and mix together. Once mixed with water you need to take it immediately!! IGF CAN ONLY SURVIVE IN WATER FOR A SMALL AMOUNT OF TIME!! Thats it!!

REMEMBER IGF FIRST, WATER SECOND and you will never have a problem.

Hope this clears things up!

Would this acetic acid work:
http://secure.sciencecompany.com/Acetic-Acid-6-16oz-P6474C670.aspx

????

 

[stat]

Hey guys first time posting here, just had a quick maybe stupid question....

Been bodybuilding for a long time, have done multiple AAS cycles and am starting to pull out some more stops so have been messing with slin and other peptides


i have done days worth of reasearch on insulin and have mostly been using it 5 on 2 off 10 ius post workout

im very interested in IGF1-LR3 as i have been reading up on it more and more

so say an average dose is 40mcg split two times a day, when do you inject? is it like insulin where its in the morning or post workout or will any time work?

also what dietary changes must happen with IGF? similart to slin or not at all??

thanks all just tryin to get a new peptide under my belt

 

[Micro]

Hey guys first time posting here, just had a quick maybe stupid question....

Been bodybuilding for a long time, have done multiple AAS cycles and am starting to pull out some more stops so have been messing with slin and other peptides


i have done days worth of reasearch on insulin and have mostly been using it 5 on 2 off 10 ius post workout

im very interested in IGF1-LR3 as i have been reading up on it more and more

so say an average dose is 40mcg split two times a day, when do you inject? is it like insulin where its in the morning or post workout or will any time work?

also what dietary changes must happen with IGF? similart to slin or not at all??

thanks all just tryin to get a new peptide under my belt

All at once PWO would be the best time. I was injecting into the muscle that I just finished working out. I would inject into Bi's, Tri's and chest, 40/60 mcg split into each muscle that I worked out that day.

You'll actually lose body fat on IGF, just think of it this way, GH increases IGF in your body. So your actually bypassing this and just injecting straight IGF. So instead of waiting months for fat loss to happen, like you when your using GH, it happens in a matter of weeks or sooner when using IGF. Well for me that's what it did.

The only comparison IGF has to Slin is that, it does lower Blood Sugar levels, not as much as Slin, but it does. Your PWO shake will take care of that.

When I first tried IGF, I was near the end of a cycle and did 5 wks worth and gain around 4/5 lbs of muscle and lost some bf.

Micro

 

[stat]

Hey thanks for the tips sounds good. Im not sure about the legality IGF1 so if this post is inappropriote im sorry please delte it...

im still trying to figure out a souce and what not and might have a few people in mind but im not sure what your getting? is it a powder or does it come similiar to a 10ml 100mcg isulin vile?

thanks again

 

[Micro]

Hey thanks for the tips sounds good. Im not sure about the legality IGF1 so if this post is inappropriote im sorry please delte it...

im still trying to figure out a souce and what not and might have a few people in mind but im not sure what your getting? is it a powder or does it come similiar to a 10ml 100mcg isulin vile?

thanks again

Make sure you get the Lyopholized IGF, which will be in powder form. 1mg comes in a small vial, I've seen them come in different sizes, mostly 3 to 5 ml vials.

Micro

 

[spectre]

so are there any sides? a mod should clean this thread up and make the 1st post complete/more clear since its a sticky.

 

[spectre]

hey guys, can it be mixed without AA and just bac water if its going to be used quickly? whats the life in the fridge if its mixed with bac water?

 

[lordsks]

After reading every post in here I'm still confused. Is there a cookie cutter explanation on reconstituting and using. I understand mixing AA with the igf for storage but what is the adding BW before using is that just to prevent the AA from burning? and if so how much BW?

 

[porterhouse]

After reading every post in here I'm still confused. Is there a cookie cutter explanation on reconstituting and using. I understand mixing AA with the igf for storage but what is the adding BW before using is that just to prevent the AA from burning? and if so how much BW?

Yeah bump for more info.

 

[Micro]

After reading every post in here I'm still confused. Is there a cookie cutter explanation on reconstituting and using. I understand mixing AA with the igf for storage but what is the adding BW before using is that just to prevent the AA from burning? and if so how much BW?

Yes the BW is used to help with the stinging, I'm pretty sure I was using a 1 to 1 ratio when adding the BW to my IGF.

Just remember the BW doesn't go into the vial of reconstituted IGF, it goes into the pin that is already loaded with IGF.

Micro

 

[porterhouse]

Yes the BW is used to help with the stinging, I'm pretty sure I was using a 1 to 1 ratio when adding the BW to my IGF.

Just remember the BW doesn't go into the vial of reconstituted IGF, it goes into the pin that is already loaded with IGF.

Micro

Thanks for pointing that out, Would it be better to draw BW first then IGF
or it does't matter since they'll get mixed in the pin anyways?

 

[Micro]

Thanks for pointing that out, Would it be better to draw BW first then IGF
or it does't matter since they'll get mixed in the pin anyways?

I know some people were doing it a certain way but I can't remember which way it was.

It's been a long time since I took IGF, I can't remember which way I was going it. It doesn't really matter to me what goes in the pin first, you just have to make sure you watch out for any suction so you don't lose any IGF if you're putting the BW in second and if you're putting IGF second you have to watch out that the IGF vial doesn't suck up some BW.

Micro

 

[porterhouse]

I know some people were doing it a certain way but I can't remember which way it was.

It's been a long time since I took IGF, I can't remember which way I was going it. It doesn't really matter to me what goes in the pin first, you just have to make sure you watch out for any suction so you don't lose any IGF if you're putting the BW in second and if you're putting IGF second you have to watch out that the IGF vial doesn't suck up some BW.

Micro

Good info thank u.

 

[No_Nonsense_Policy]

I love it and use it on my off days as well and since I have I am growing and getting stronger. Doing the whole stack now on certain movements applying 80mcgs bi laterally. Running test, winny tabs, gh, and tren enan also.

 

[No_Nonsense_Policy]

I know some people were doing it a certain way but I can't remember which way it was.

It's been a long time since I took IGF, I can't remember which way I was going it. It doesn't really matter to me what goes in the pin first, you just have to make sure you watch out for any suction so you don't lose any IGF if you're putting the BW in second and if you're putting IGF second you have to watch out that the IGF vial doesn't suck up some BW.

Micro

a lot comes reconstituted already or they sell aa and just add 1ml if you have 1mg of igf 1 r3. vent with a diff needle and slowly drip solution down the side of the vial.

 

[toddski]

i have read several thereds about using AA vs. BW.... to avoid all the confusion, not to mention the burn of AA and its effects on the skin (killing it), i decided to go with BW. now it may be true it won't last for a year in BW, but wtf would i wanna mix and store for a year for?? I mixed 2ml BW in a 1mg IGF1-DES vial. when i pull back to the 20 on a 1ml slin pin or 10 ticks, that gives me 100mcg. I'll pin this bilateral, post workout into the muscles worked to "hopefully" encouarage new cell growth. This will give me 10 days of use in one vial. i'll use only on workout days total of 4 weeks on and 4 weeks off... I went with the IGF1 DES over the LR3 simply due to the more localized effects and hopefully prevent excess IGF from making its way to the intestine where our bodies have the most IGF receptors (no interest in the Ronnie Coleman gut).

 

[Gulfcoastgorill]

I always thought igf-1 lr3 was only good for about 3 weeks in the refrigerator after it is made up. This post says six months in room temperature. Anyone know if I am misinformed?

 

[Gulfcoastgorill]

I'm speaking of putting it in 3cc of aa by the way